The lightbar shows the player's health (green to amber to red) or the
dimension, at half brightness, chosen in the controller options (Lightbar:
Health / Dimension / Off; health by default). The player LEDs show player 1.
When Horizon lets go of the pad, the lights it changed go back to a host's
defaults.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Every report carries the motors; still motors send no rumble flags, as SDL
stops rumble (a report without them ends the emulation and re-arms the
audio haptics), so a trigger change no longer cuts a vibration.
- Legacy vibration at half strength (SDL); the Edge always takes V2; an
unreadable firmware version falls back to legacy.
- The first report after opening clears the motor/trigger attenuation
(flags 1 bit 6, byte 36; dualsensectl, pydualsense).
- The LED reset goes in a report of its own before any colour
(hid-playstation's dualsense_reset_leds); over Bluetooth the colour waits
for the connection animation (SDL's sensor clock check).
- Bluetooth output only where gilrs keeps reading the pad (Linux), else with
HORIZON_DUALSENSE_BT=1: any output switches the pad to its full report.
- USB is preferred when the pad is on both.
- Tests pin the reset report and its CRC (zlib), the flags and the clock offset.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
The horizon-dualsense crate builds the DualSense's output report (USB 0x02,
Bluetooth 0x31 with its CRC-32 seeded with 0xA2) and writes it with hidapi
from a thread. The game sends its rumble pulses through it when the active
pad is a DualSense, so vibration now works on macOS too, and falls back to
gilrs force feedback when the pad can't be opened. Quitting frees the
triggers and stops the motors.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>